Lab R3: OSPF v2/v3
An OSPF fault is nearly always a disagreement: two routers that differ about an area, a type or a secret, or an area that has been told a rule its neighbors have not. To spot the disagreement later you need to have seen each rule do its work once, on purpose. This network has one of each: a backbone, an area that only carries others through, an area cut off from the backbone, an area that wants no outside routes, and an area that wants none and still has one of its own to announce.
What you will do
- Five areas
- An area that cannot see the backbone
- A route from outside OSPF
- An area that wants less, and then nothing
- No outside routes in, one outside route out
- A backbone link that asks who is there
- The same design in IPv6
- Keep it
New in this lab: address families, network types, stub, NSSA, totally stub, virtual link, authentication.
How it is checked
Each of the 8 tasks is checked on the devices themselves as you finish it: the bench reads how the network is configured and what it does, not what you typed. The lab is done when all 8 pass.
The lessons it follows
It opens after these, and uses what they teach:
Open the lab benchIt needs a computer: phones and tablets are not supported.
