Lab E6: Multi-area OSPF

One area is one map: every router in it holds every link, and works its routes out again whenever any of them changes. Past a certain size that is too much. So the network is cut into areas joined through a backbone, and a router that sits on a border tells each side about the other in a few lines, not link by link. You will build three areas, then decide what the borders say.

In Daveth Pro (Network)Build it from the brief · Five routers · 7 tasks

What you will do

  1. Addresses
  2. Three areas
  3. What the backbone was told
  4. One line for four networks
  5. A network that stays home
  6. The same areas, in IPv6
  7. Save all five

New in this lab: areas, summary, filter, passive, OSPFv3.

How it is checked

Each of the 7 tasks is checked on the devices themselves as you finish it: the bench reads how the network is configured and what it does, not what you typed. The lab is done when all 7 pass.

The lessons it follows

It opens after these, and uses what they teach:

Open the lab benchIt needs a computer: phones and tablets are not supported.