VLANs for CCNA 200-301

Every VLANs lesson in the CCNA 200-301 course, in the order you study them. Each page opens about the first half of its lesson to read, some the whole of it; the full lessons, their videos and labs are in the plan.

6 lessons · 65 min of video · 3 labs

  1. VLAN concepts and access ports

    Why one switch can hold two separate networks: what a VLAN is, what an access port does with a frame, and why hosts in different VLANs need a router.

    13 min video

  2. Configure and verify VLANs

    Create a VLAN, put access ports in it and prove it with show vlan brief. Plus what a Cisco switch does when a port names a VLAN that does not exist.

    11 min video

  3. 802.1Q Trunking and Native VLAN

    802.1Q trunking for CCNA: why VLANs need trunks between switches, VLAN tagging, the 4-byte 802.1Q header, ISL, and the untagged native VLAN.

    11 min video · lab: Trunks

  4. Trunk Negotiation and VLAN Trunking Protocols

    DTP and VTP for CCNA: administrative and operational trunk modes, the four switchport mode options, which pairs form a trunk, and what VTP shares.

    10 min video · lab: Trunks

  5. Voice VLANs and IP Phone Interfaces

    Voice VLANs for CCNA: one cable for an IP phone and a PC, the data VLAN and the voice VLAN on one port, and the switchport voice vlan command.

    7 min video · lab: VLANs

  6. Troubleshooting VLANs and Trunks

    Troubleshooting VLANs and trunks for CCNA: check the access ports, whether the VLAN exists and is active, and whether both ends of the link trunk.

    13 min video