Lab N15: OSPF
In the last lab every route was typed, on both routers, twice over for the spare cable. Three routers would be worse and thirty impossible. A routing protocol has the routers tell each other what they are connected to and work the routes out themselves. This one is OSPF.
What you will do
- Addresses, again
- A name for each router, then OSPF
- Who R1 has found
- One router speaks for the network
- Choose the DR
- Two routers, nothing to elect
- What R1 was told
- Break something
- Mend it
- Save all three
New in this lab: adjacency, router ID, point-to-point, DR/BDR.
How it is checked
Each of the 10 tasks is checked on the devices themselves as you finish it: the bench reads how the network is configured and what it does, not what you typed. The lab is done when all 10 pass.
The lessons it follows
It opens after these, and uses what they teach:
Open the lab benchIt needs a computer: phones and tablets are not supported.
